6
99
Parking assist system
Reversing radar system
The reversing radar system is automatically
turned on after the driver shifts to reverse
gear (R) to avoid collision with obstacles
during parking.
The reversing radar sensor at the rear of
the vehicle can detect objects up to 1.5m
behind the vehicle.
However, the ultrasonic parking
assist system cannot replace visual
detection by the driver. It may not
detect:
• Objects under the vehicle, or
objects that are too close to or far
from the vehicle.
• Children, pedestrians, cyclists or
pets.
• Very tiny objects may not be
detected.
If you fail to pay attention to the
situation behind the vehicle before
or during reversing, it may lead to
vehicle damage, personal injury and
even death. Even if the parking assist
system is equipped, the driver must
observe carefully before reversing.
During reversing, you must observe
whether there are obstacles and pay
attention to the rearview mirror of
the vehicle.
System operation
After the vehicle is shifted to reverse gear
(R), the reversing radar system will be
turned on automatically. When the vehicle
exits reverse gear (R), the system will
automatically shut down.
The reversing radar system cannot be
activated until the reverse gear (R) is
engaged. When the system is working, if an
obstacle enters the detection range, the
buzzer of vehicle instrument will prompt
that there are obstacles behind the vehicle.
The closer the vehicle gets to the obstacle,
the faster the buzzer sounds. When the
distance between obstacles is less than 30
cm, a continuous sound alarm will be
heard. In hot or humid weather, the
distance of detecting objects may
decrease.
Distance from
obstacle
Alarm frequency
70cm~150cm
Intermittent sound
30cm~70cm
Intermittent rapid
sound
＜30cm
Continuous sound
The system may not give an
alarm.
Please note that the rear reversing radar
system sensor may not give an alarm in the
following cases:
Starting and driving
To Next Page
Loading...
Need help?
General
