70
Use of seat belt
The seat belts used on both sides of the
vehicle are three-point seat belts. The
following instructions will clarify how to
wear the seat belt correctly.
1. Pick up the latch and pull the seat belt
across your body. Don't twist the seat
belt.
If the seat belt is pulled over the
body too fast, it may be locked. If this
happens, unlock the seat belt by
retracting it a little. Then slowly pull
the seat belt across the body.
2. Press the latch into the buckle until you
hear a click sound. Pull the latch to
make sure it is locked. Locate the
release button on the buckle so that
the seat belt can be unfastened quickly
if necessary.
3. Pull up the shoulder belt to tighten the
hip belt.
4. If you want to unfasten your seat belt,
just press the red button on the
buckle. Seat belts should be rolled
back to the unused status.
To prevent the seat belt from
bumping the periphery due to too
fast rolling or getting stuck due to
too slow rolling, please put the seat
belt back to its original position after
unfastening it.
Before closing the door, make sure
that the seat belt will not be caught
by the door. If the door is closed
hard when the seat belt is clamped,
both the seat belt and the vehicle will
be damaged.
Use of seat belts for pregnant
women
Seats and protective devices
To Next Page
Loading...
Need help?
General
