94
the applied brake force vary. Unnecessary
emergency braking should be avoided.
Some people tend to make sudden
operations during driving, accelerating
suddenly and then braking urgently
instead of keeping pace with the traffic
flow. This is wrong. The brake may have no
time to cool down between several
emergency stops. If you depress the brake
pedal frequently, it will accelerate the wear
of the brake. If you drive at a speed
consistent with that of the traffic flow and
keep a certain distance between vehicles,
unnecessary braking will be greatly
reduced. This means better braking effect
and longer service life of the brake. Adding
non-original accessories will affect the
performance of your vehicle.
Emergency brake reminder
When the vehicle performs emergency
braking, the hazard warning lamp will flash
at a certain frequency to remind the rear
vehicle that it is performing emergency
braking. Please pay attention to keeping
distance between vehicles.
In winter, the ice and snow on the
brake system will affect the braking
performance. Please clean them in
time.
When the brake pedal is depressed,
if there is sharp metal friction sound
at the vehicle brake, check whether
the brake pad has worn to the
minimum thickness in time. If the
brake pad is worn to the minimum
thickness, replace it immediately to
ensure driving safety.
Do not put your foot on the brake
pedal during driving. Otherwise, the
brake components will be worn and
overheated, and the braking distance
will be increased.
Mechanical parking brake
1. Parking brake button
2. Parking brake handle
Pull up the parking brake handle (about
6~10 teeth) to apply the parking brake;
press the parking brake button, pull up the
parking brake handle slightly, and then fully
release the parking brake handle to
release the parking brake.
Be sure to tighten the parking brake
handle firmly and do not operate the
Starting and driving
To Next Page
Loading...
Need help?
General
