8
139
fourths of its volume to allow
expansion of the washer fluid when it
is frozen and avoid damage due to
lack of expansion space.
If concentrated washer fluid is used,
please add water to dilute it
according to the manufacturer’s
instructions.
Do not add water to the ready-to-use
washer fluid. Adding water may
cause the washer fluid to freeze and
damage the washer fluid reservoir or
other parts of the scrubber system.
Moreover, the cleaning ability of
water is not as good as that of
washer fluid.
Wiper blade
Grease, silicon and petroleum
products tend to weaken the wiping
effect of wiper blades. Wash the
wiper blades in warm soapy water
and check their condition regularly.
Clean the windshield frequently, and
try to avoid using the wiper blades to
clear the sand on the windshield, so
as not to affect the wiping effect of
the wiper blades and reduce their
service life.
If rubber hardening or cracks are
found, or the wiper scratches the
windshield or it cannot wipe a certain
area, the wiper blade needs to be
replaced.
Clean the windshield regularly with
appropriate washer fluid, and ensure
that the windshield is thoroughly
cleaned before replacing the wiper
blade. Use the wiper blade of the
same specification as the genuine
wiper only.
If the wiper or windshield is covered
by ice and snow or is frozen, clean
off the ice and snow before using the
wiper blade so as to avoid damage of
wiper.
When the windshield is dry and there
are hard objects on its surface, do
not use wiper; otherwise, wiper
blade and windshield may be
damaged.
Replacement of wiper blade
Check whether the wiper blade is aged,
worn or broken. To replace the wiper
blade:
1. Pull the wiper blade assembly away
from the windshield.
2. Press the wiper blade fixing tongue,
and pull the wiper blade in the
direction of arrow to loosen it from the
wiper arm.
3. Remove the wiper blade.
When the wiper blade is not
installed, do not allow the wiper arm
to contact the windshield; otherwise,
Repair and Maintenance
To Next Page
Loading...
Need help?
General
