63
Announcement (AMPLIDECT285™ only)
It is necessary to record the announcement which
requests the caller to leave a message when nobody is at
home. The answer and record message (Announce1)
and the answer only message (Announce2) can be up to
3 minutes respectively.
Record Announce1
Auto-answer Announce1 is a conventional message
requesting you to leave a message. If you have not
recorded a personal Announce1, the unit will play the
default one "Hello, your call cannot be taken at the
moment, to record your message, please speak after
the tone".
If you want to change Announce1, do the following steps
to update it:
1. Press the TAM soft key in Standby mode.
2. Press the Select soft key to choose Announce.
3. Press Select key again to choose Announce1.
4. Press the
or key repeatedly to choose
Record, press the Select soft key.
5. You can record your announcement after a tone.
Recording will stop automatically after 3 minutes. You
can also confirm and end the recording by pressing the
OK key. During recording the LCD shows "Recording...".
TAM FUNCTIONS(AMPLIDECT285™ ONLY)
To Next Page
Loading...
