64
Record Announce2
Announce-only Announce2 is an answer-only message.
If you have not recorded a personal Announce2, the
unit will play the default one "Hello, your call cannot be
taken at the moment, please call back later".
If you want to change Announce2, do the following steps
to update it:
1. Press the TAM soft key in Standby mode.
2. Press the Select soft key to choose Announce.
3. Press
or key repeatedly to choose
Announce2, then press the Select key to confirm.
4. Press the
or key repeatedly to choose
Record, press the Select soft key.
5. You can record your message after a tone. Recording
will stop automatically after 3 minutes. You can also
confirm and end the recording by pressing the OK key.
During recording the LCD shows "Recording...".
Use the base to record Announce1
/Announce2
Press and hold the or key on the base unit
until the system announce. Begin speaking after you
hear the beep. Use the
key to finish at any time.
TAM FUNCTIONS(AMPLIDECT285™ ONLY)
To Next Page
Loading...
