8
ACCESSING THE EXT-DSC HTTP SERVER (PC)
be connected to a display: allow about 1 minute for the EXT-DSC to boot up,
you will see the green light blinking once per second).
4. Confi gure the network on your PC.
You need to confi gure your PC to have the following network confi guration:
► A static address assigned by your network administrator. This must be
on the same subnet as the EXT-DSC unit.
► A IP address automatically assigned by a DHCP server located on the
same network as the EXT-DSC unit.
5. Validate that the above steps are successful:
a. Make sure that the EXT-DSC has completed the booting phase: allow
about 1 minute from the EXT-DSC power up. If you have connected the
EXT-DSC to a display you should see the default animated logo.
b. Check that the LED is blinking green once per second. If this is not the
case go to the troubleshooting section at the end of this guide.
c. Open a Web Browser (e.g. Internet Explorer, Firefox...) and type into the
location bar at the top:
http://gef-dsc-XXXXXXXXXXXX.local
Please replace the 12 X’s with the MAC address (without colons) of the
EXT-DSC unit. This is located on a sticker on the underside of the unit.
6. The browser should connect to the EXT-DSC HTTP server and display the
following page:
To Next Page
Loading...
