page | 10
Getting Started
Installation
Supplementary Connections
► USB (see USB Control for more information on using USB devices)
1. Connect a USB cable from the computer to the USB port on the Sender unit.
2. Connect up to two USB devices to the Receiver unit.
► IR
3. Connect a Gefen IR Emitter (Gefen part no. EXT-2IREMIT) to the Sender unit and
attach it to the IR sensor on the device to be controlled.
4. Connect an IR Extender (Gefen part no. EXT-RMT-EXTIRC or EXT-RMT-EXTIRN)
to the Receiver unit if the IR sensor will not be within line-of-site for proper IR control.
► Audio (see Audio Connections for more information on using audio devices)
7. Connect a 3.5mm mini-stereo cable from the Line In jack on the Sender unit to an
audio source.
8. Connect a pair of powered speakers (or another audio output device) to the Line Out
jack on the Receiver unit.
9. Connect a microphone to the Mic In jack on the Receiver unit.
10. Connect a pair of powered speakers (or another audio output device) to the Line Out
jack on the Sender unit.
► RS-232
11. Connect the included RS-232 cable from the PC or automation system to the
RS-232 port on the Sender unit.
12. Connect an RS-232 cable from the Receiver unit to the RS-232 device to be
controlled.
To Next Page
Loading...
