gefran 850 - OUT2.S - Number of Switchings Output 2; OUT3.S - Number of Switchings Output 3; OUT4.S - Number of Switchings Output 4; INDG.S - Digital Input Switchings Number

80209C_MHW_850-1650-1850_02-2020_ENG_pag. 64
4.4.29. OUT2.S - Number of switchings output 2
Acronym Scrolling message Submenu Attributes
OUT2.S NUMBER X 1000 RELAY CYCLES INFO R
If output 2 is available on the controller, the parameter shows the number of switchings (in thousands).
Unit of measurement: Number (× 1000)
Options: -
4.4.30. OUT3.S - Number of switchings output 3
Acronym Scrolling message Submenu Attributes
OUT3.S NUMBER X 1000 RELAY CYCLES INFO R
If output 3 is available on the controller, and if it is relay or logic, the parameter shows the number of switchings (in thou-
sands).
Unit of measurement: Number (× 1000)
Options: -
4.4.31. OUT4.S - Number of switchings output 4
Acronym Scrolling message Submenu Attributes
OUT4.S NUMBER X 1000 RELAY CYCLES INFO R
If output 4 is available on the controller, the parameter shows the number of switchings (in thousands).
Unit of measurement: Number (× 1000)
Options: -
4.4.32. NDG.S - Digital input switchings number
Acronym Scrolling message Submenu Attributes
INDG.S NUMBER OF DIGITAL INPUT CYCLES INFO R
If a digital input with the F.in=CY.CNT function is configured on the controller, the parameter shows the number of swi-
tchings performed.
Unit of measurement: Number
Options: -
4.4.33. T.DAYS - Total working days
Acronym Scrolling message Submenu Attributes
T.DAYS TOTAL DAYS OF OPERATION INFO R
The parameter shows total number of working days of the controller since first power-on. Each working day equals 24
hours of actual functioning.
Unit of measurement: Day
Options: 0...9999