gefran 850 - EVN.R.2 - Evento 2 Durante la Rampa del Passo; EVN.R.3 - Event 3 During Step Ramp; EVN.R.4 - Event 4 During Step Ramp; EVN.H.1 - Event 1 During Step Hold

80209C_MHW_850-1650-1850_02-2020_ENG_pag. 81
4.8.22. EVN.R.2 - Evento 2 durante la rampa del passo
Acronym Scrolling message Submenu Attributes
EVN.R.2 PR.STP.1 (o PR.STP.2…PR.STP.192) EVENT DURING STEP RAMP se moda-
lità“Programmatore semplificato”disattiva; o PR.STP.1…PR.STP.16 EVENT
DURING STEP RAMP se modalità“Programmatore semplificato”attiva.
PR.STP R W
The parameter shows and sets the configuration of event 2 during the step ramp
Unit of measurement: -
Options: nonE = Event not modified
On = Event becomes active
OFF = Event becomes inactive
4.8.23. EVN.R.3 - Event 3 during step ramp
Acronym Scrolling message Submenu Attributes
EVN.R.3 PR.STP.1 (o PR.STP.2…PR.STP.192) EVENT DURING STEP RAMP se moda-
lità“Programmatore semplificato”disattiva; o PR.STP.1…PR.STP.16 EVENT
DURING STEP RAMP se modalità“Programmatore semplificato”attiva.
PR.STP R W
The parameter shows and sets the configuration of event 3 during the step ramp
Unit of measurement: -
Options: nonE = Event not modified
On = Event becomes active
OFF = Event becomes inactive
4.8.24. EVN.R.4 - Event 4 during step ramp
Acronym Scrolling message Submenu Attributes
EVN.R.4 PR.STP.1 (o PR.STP.2…PR.STP.192) EVENT DURING STEP RAMP se moda-
lità“Programmatore semplificato”disattiva; o PR.STP.1…PR.STP.16 EVENT
DURING STEP RAMP se modalità“Programmatore semplificato”attiva.
PR.STP R W
The parameter shows and sets the configuration of event 4 during the step ramp
Unit of measurement: -
Options: nonE = Event not modified
On = Event becomes active
OFF = Event becomes inactive
4.8.25. EVN.H.1 - Event 1 during step hold
Acronym Scrolling message Submenu Attributes
EVN.H.1 PR.STP.1 (o PR.STP.2…PR.STP.192) EVENT DURING STEP HOLD se moda-
lità“Programmatore semplificato”disattiva; o PR.STP.1…PR.STP.16 EVENT
DURING STEP HOLD se modalità“Programmatore semplificato”attiva.
PR.STP R W
The parameter shows and sets the configuration of event 1 during the step hold.
Unit of measurement: -
Options: nonE = Event not modified
On = Event becomes active
OFF = Event becomes inactive