Dual Hand Controls
Your Gehl loader may be equipped with the dual hand control option. The left
handle controls the left side drive and the lift. The right handle controls the
right side drive and the tilt.
Drive Control
Forward, reverse, speed and turning maneuvers are accomplished by pushing
and pulling the handles. To go forward, push both handles forward; for
reverse, pull both handles rearward. For turning, move one handle farther
forward or rearward than the other handle. Turn direction is determined by
which handle is moved farther forward; to turn left, move the right handle
farther forward than the left handle. For sharp turns, move the handles in
opposite directions.
Moving the handles farther from neutral increases the speed steadily to the
maximum travel speed. Tractive effort decreases as speed increases. To get
maximum tractive effort, move the handles only slightly away from the
neutral position. The engine will stall if the control is moved too far when
loading the bucket.
Be sure the controls are in neutral before starting the
engine. Operate the controls gradually and smoothly. Excessive speed
and quick control movements without regard for conditions and
circumstances are hazardous and could cause an accident.
27 908268/BP0904
WARNING
To Next Page
Loading...
