917001/CP0905 75
CHAPTER 7
MAINTENANCE
This Maintenance Interval Chart was developed to match the Service chapter of this
manual. Detailed information on each service procedure may be found in the Ser-
vice chapter. A Maintenance Log follows the chart for recording the maintenance
performed. Recording the 10-hour (or daily) service intervals would be impractical
and is therefore not recommended.
Important: Under severe operating conditions, more frequent service than the
recommended intervals may be required. You must decide, based on your use, if
your operation requires more frequent service.
Service Procedure
Maximum Interval
10 Hours
(or Daily)
250 Hours
500 Hours
(or Annually)
Foreign Material Removal (page 51)
l
Check Engine Air Cleaner Restriction Indicator
(page 55)
l
Check Engine Oil Level (page 57)
l
Check Hydraulic Oil Level (page 59)
l
Check Tire Pressures (page 62)
l
Grease Lift Arm, Hitch, Cylinder Pivots and
Latch Pins (page 51)
l
Check Bucket Cutting Edge (page 60)
l
Test Safety Interlock System (page 18)
l
Check Coolant Level (page 61)
l
Clean Cooling System (page 61)
l
Check Drive Chain Tension (page 55)
l
Check Wheel Nuts Torque (page 60)
ml
Check All-Tach Pivot Torque (page 60)
l
Check Oil Level in Chaincases (page 54)
l
Check Alternator/Fan Belt Tensions (page 60)
l
Change Engine Oil and Filter (page 58)
ov l
Change Hydraulic Oil Filter (page 59)
ol
Check Battery (page 63)
l
Check Engine Mounting Hardware (page 57)
l
Change Fuel Filters (page 59)
l
Change Hydraulic Oil (page 60)
u
Change Chaincase Oil (page 54)
ou
m
Perform the initial procedure at 2 hours then at “l” intervals.
o Perform the initial procedure at 50 hours then at “z” or “u” intervals.
v Severe operating conditions.
u Perform the procedure at 1000 hours.
https://tractormanualz.com/
To Next Page
Loading...
