60 917387/BP0310
Inner Element
Note: Replace the inner element only if it is visibly dirty or if the outer element
has been replaced three times.
1. Before removing the inner element from the housing, clean out any dirt built
up in the housing. Leave the inner element installed during this step to pre-
vent debris from entering the engine intake manifold.
2. Remove the inner element.
Reinstallation
1. Check the inside of the housing for any damage that may interfere with the
elements.
2. Be sure that the element sealing surfaces are clean.
3. Insert the element(s), making sure that they are seated properly.
4. Secure the cover to the housing with the three clamps.
5. Check the hose connections and make sure they are all fitted and tightened
properly.
6. Reset the indicator by pressing the reset button.
Note: Periodically inspect intake system tubes, rubber elbows and connections.
Inspect for cracks, loose fits and loose clamps. Tighten or replace as needed.
Intake system must be air tight.
To Next Page
Loading...
