Gehl V270 - Troubleshooting

917387/BP0310 73
CHAPTER 6
TROUBLESHOOTING
Electrical System
Problem Possible Cause Remedy
Entire electrical
system does not
function.
Battery disconnect switch is
in OFF position.
Turn battery disconnect
switch to ON.
Main wiring harness
connectors at rear of ROPS/
FOPS not properly plugged in.
Check main harness
connectors.
Faulty keyswitch. Replace keyswitch.
10 amp fuse blown (key
switch).
Replace keyswitch.
Battery terminals or cables
loose or corroded.
Clean battery terminals and
cables and retighten them.
Battery is faulty. Test battery, replace as
needed.
No instrument panel
lamps with keyswitch
turned to “ON.”
Fuse has blown. Replace fuse.
Main wiring harness
connectors at rear of ROPS/
FOPS not properly plugged in.
Check main harness
connectors.
Battery terminals or cables
are loose or corroded.
Clean battery terminals and
cables and retighten them.
Fuel gauge does not
work.
Faulty fuel gauge sender. Replace fuel gauge sender.
Faulty fuel gauge. Replace fuel gauge.
Fuse has blown gauge. Replace fuse.
Loose wiring/terminal
connections.
Verify wiring connections.
Engine temperature
gauge does not work.
Faulty temperature sender. Replace temperature sender.
Faulty temperature gauge. Replace temperature gauge.
Fuse has blown gauge. Replace fuse.
Loose wiring/terminal
connections.
Verify wiring connections.
Hourmeter does not
work.
Loose wiring/terminal
connections.
Verify wiring connections.
Faulty alternator. Repair alternator.
Fuse has blown. Replace fuse.
Faulty hourmeter. Replace hourmeter.