EasyManua.ls Logo

Gehl V270 - Page 78

Gehl V270
102 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
74 917387/BP0310
Starter will not
engage when key is
turned to START.
Battery terminal or cables
loose or corroded.
Clean terminal, cables and
retighten
Battery discharged or
defective.
Recharge or replace battery.
Seat or restraint bar switch
malfunctioning or not
actuated.
Contact your dealer.
Ignition wiring, seat switch,
restraint bar switch, etc.
loose or disconnected.
Check wiring for poor
connections, broken leads;
repair wiring or connection.
Start safety relay malfunction
located in fuse panel.
Verify proper operation.
Starter solenoid not
functioning.
Contact your dealer.
Starter relay malfunctioning. Verify relay is working
properly, replace.
Starter or pinion faulty. Remove starter; repair/
replace as needed.
Engine fault code: (ECU will
not allow crank if certain
faults are present).
Contact your dealer.
Work lights not
functioning properly.
Single light not working; light
bulb burned out, faulty
wiring.
Check and replace light bulb
as needed. Check wiring
connection to light.
No lights; 30 ampere light
fuse blown.
Check circuit and locate
trouble before replacing fuse.
Faulty light switch or poor
ground.
Check ground wire
connections. Replace light
switch.
Engine fault code: (ECU will
not allow crank if certain
faults are present)
Contact your dealer.
Lift/Tilt and/or drive
solenoids do not
work.
Wiring to solenoids
disconnected or faulty.
Troubleshoot circuit, repair.
Restraint bar or seat switch
malfunction.
Contact your dealer.
Faulty solenoid valve coil. Contact your dealer.
Solenoid relay
malfunctioning.
Verify relay is working
properly, replace.
Faulty fuse panel. Verify relay is working
properly if not, replace.
Electrical System
Problem Possible Cause Remedy

Related product manuals