7. Basic Precautions
1-3
WARNING Neglecting these instructions may cause extreme hazards.
• Unauthorized modifications may cause safety hazards.
• When you wish to modify your machine, contact your dealer. The implementation of unauthorized
modifications or the use of unauthorized attachments could result in bodily injury, since those ac-
tions would also violate, the terms of the Warranty, it would be voided
• When leaving the operator's seat, be sure to place the lock lever in the lock position, to prevent
accidental machine movement which could result in bodily injury.
• When you leave the machine:
(1) Lower the bucket to the ground.
(2) Place the lock lever in the lock position.
(3) Stop the engine.
(4) Set all the locks in to the lock position.
(5) Be sure to take the key out of the starter switch.
For information on parking the machine, refer to Section
"13-15. Parking the machine".
• Do not jump on or off the machine. Never get on or off a machine in motion as it may result in bodily
injury.
• When getting on and off the machine, face the machine and use the handrails and steps.
• Do not use control levers as handrails.
• Make sure that you maintain three point contact with the handrails or the steps.
• If the handrails and the steps are soiled with oil or dirt, clean them off immediately.
Repair any damaged parts and retighten any loose bolts.
Avoid unauthorized modifications
Always lock up your machine when leaving the operator's seat
Use handrails and steps when getting on and off
Lock
(Left side)
Lock lever
008999-00
009177-00
.
To Next Page
Loading...
