12. Description of Control Devices
2-5
(1) Fuel gauge
The fuel gauge works while the starter switch key is in the
“ON” position and indicates the fuel amount in the fuel
tank. When the gauge pointer indicates close to E (empty),
refill fuel oil soon.
• It is not abnormal that the fuel gauge may not indicate
properly immediately after the starter switch key is
turned to the “ON” position.
• The reading on the fuel meter scale is affected by how
much the machine is slanted.
(2) Water temp meter
This indicates water temperature for engine.
When the water temp. meter indicates "H" and buzzer
sounds during operation, idle the engine at low speed until
the water temperature cools down.
(3) Engine oil pressure alarm lamp
If engine oil pressure falls below the normal level, the
alarm lamp will turn on and the buzzer will sound. In this
event, stop the engine and inspect it according to Section
"17-4. Troubleshooting".
(4) Battery charge alarm lamp
If the battery is not charged properly, the alarm lamp will
flash. In this event, inspect the battery charging circuit. If
you find something abnormal with it, take corrective action
by referring to Section "17-4. Troubleshooting".
(5) Water temp alarm lamp
When the starter switch is turned to the "ON" position, the
alarm lamp goes on and then goes off in a few seconds.
When the cooling water temperature rises abnormally dur-
ing operation, the alarm lamp goes on and the buzzer
sounds, indicating engine overheating.
Idle the engine for a while, and stop the engine. After the
engine has cooled, take corrective actions.
000319-00X
White
000320-00E
000321-00X
000322-00X
000323-00X
To Next Page
Loading...
