Maintenance of the power generator
Page 31
6. MAINTENANCE OF THE POWER GENERATOR
The periods between maintenance work may vary from case to case depending on the importance
of the system as well as environmental and usage conditions. As a general rule, an initial inspection
is recommended after about 100 operating hours, but after one year at the latest. After this, it should
also be done whenever maintenance is performed on the drive motor. During maintenance work,
checks are made that:
• Generator runs without any abnormal noise or vibrations which may lead to bearing damage
• Operating data are correct
• Air inlet is not blocked
• Cables show no signs of wear
• Electrical connections are securely fastened
• Nuts and bolts are all properly tightened.
6.1. Maintenance of the drive motor
For maintenance on the drive engine, follow the maintenance plan in the operating manual of the
engine or have your authorised dealer carry out the necessary work.
I WARNING
fUElS AND fUEl vApOUrS ArE flAMMAblE/EXplOSIvE
fUElS AND fUEl vApOUrS ArE TOXIC
Risk of serious injuries leading to death
• Only refuel or handle fuel with the engine o!
• Never refuel near open ames, sparks or other sources of ignition.
• Do not smoke!
• Do not spill fuel! Immediately wipe up any drips!
• Pay attention to ventilation!
• Use protective gloves
Initiate life-saving emergency measures
I CAUTION
HOT ENgINE pArTS Or HOT OpErATINg MATErIAlS
Danger of burning or danger of scalding body parts
• Allow the engine to cool o
• Use protective gloves.
Cool the site of the injury
Provide rst aid in accordance with guidelines and/or notify rst responders.
NOTE
Used motor oil is to be disposed of in an environmentally friendly manner. Used oil may neither
be put in amongst general waste nor poured into the sewer system, into a drain or on to the
ground.
We recommend placing used oil in a sealed container and handing it to a recycling centre or a
customer service centre for recycling.
To Next Page
Loading...
