Page4
owner's manual
rp800
Page5
owner's manual
rp800
REVERB: Selecting or modifying a reverb in a preset
Each of the Rp 800 recalled presets includes a reverb. The reverb type selection is notified by the
corresponding led on the panel. Press the reverb button to change the reverb type.
Edit the "reverb send" value for a selected preset
It is possible to customize the default reverb level set
from the factory. Keep the REVERB button pressed
for more than two seconds. The section leds start
The display enters the reverb send edit mode showing:
At this point press the BALANCE/DATA buttons. The
first time you press the button the display shows the
current send level value. To modify the value press the
If you're using a LAYER or SPLIT mode sound, it is
possible to change the reverb send for any of the
enabled sections. Enter the reverb send edit mode.
Press the SELECT/TEMPO button >. The display
switches to the layer section
The editing procedure is the same as in the main
Pressing again the SELECT/TEMPO button >. The
display switches to the split section.
In this way even reverb sends of the the split section