Cinterion
®
Java Terminal Hardware Interface Description
6.5 Compliance with FCC and IC Rules and Regulations
61
PLS62T-W_HID_v01 2018-06-20
Confidential / Prelimenary
Page 60 of 91
6.5 Compliance with FCC and IC Rules and Regulations
As an integrated product, the Java Terminal PLS62T-W USB and PLS62T-W LAN are fully
compliant with the grant of the FCC Equipment Authorization and the Industry Canada Certifi-
cates issued for the built-in Java modules, and therefore, bear the labels “Contains FCC ID:
QIPPLS62W”.
The Equipment Authorization Certification for the Cinterion
®
Java modules is listed under the
following identifiers:
FCC Idenitifier: QIPPLS62W
Industry Canada Certification Number: 7830A-PLS62W
Granted to Gemalto M2M GmbH
Notes (FCC):
Radiofrequency radiation exposure Information:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled envi-
ronment. This equipment should be installed and operated with minimum distance of 20 cm be-
tween the radiator and your body. This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
This terminal equipment has been tested and found to comply with the limits for a Class B dig-
ital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reason-
able protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accor-
dance with the instructions, may cause harmful interference to radio communications. Howev-
er, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be de-
termined by turning the equipment off and on, the user is encouraged to try to correct the inter-
ference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications made to this equipment not expressly approved by Gemalto M2M
may void the FCC authorization to operate this equipment.
This device contains UMTS, GSM and GPRS class functions in the 900, 1800 and 2100MHz
bands that are not operational in U.S. Territories. This device is to be used only for mobile and
fixed applications.
Users and installers must be provided with antenna installation instructions and transmitter op-
erating conditions for satisfying RF exposure compliance: For more information on the RF an-
tenna interface please refer to Section 3.16 and Section 4.5.
To Next Page
Loading...
Need help?
General