Genadyne Biotechnologies | DMR-06-091- Rev F
Adjusting the Pressure
At any given point in time (except when the keypad is locked), whether the system is On or Off, whether
it is on a therapy or not, the user can adjust the pressure by pressing the Up button to increase the
vacuum pressure or the Down button to decrease the down pressure.
The adjustment to this pressure setting is displayed by the large digit in the center of the LCD screen.
Each key press corresponds to either a 1 mmHg increment / decrement. By holding down the key, it
will gradually change to a 10 mmHg increment / decrement.
Intensity Mode
The Intensity Mode has 3 basic settings. The Intensity Mode is for users to adjust the speed of
suction of the XLR8+ device. Setting 1 will run at the lowest speed, while Setting 3 will run at the
highest speed.
Alerts
There are 6 Alert Notifications in the XLR8+.
Whenever there is a leak in the dressing or the canister, the Leak Alert will
occur.
The message on the screen will show:
To Next Page
Loading...
