Genadyne XLR8 Plus - Dressing Application Procedure

Genadyne Biotechnologies | DMR-06-091- Rev F
27
Dressing Application
Step 1
Choose appropriate size of XLR8 foam kit for
wound.
Step 2
Clean the wound according to the agency / facility
protocol. Protect wound edges with the XLR8
drape if necessary.
Step 3
Cut foam to appropriate size of the wound. Place
the foam into the wound. Avoid cutting the foam
over the wound. Do not over pack.
Step 4
Cover foam with XLR8 drape. Peel layers 1, 2,
and 3. Remove the handlers.
Step 5
Cut a hole on the drape in the middle of the foam
approximately 1” in diameter. Remove paper
backing (number 1) from the port pad*. Place over
the hole. Peel number 2. Remove handlers.
*Actual port pad may be different from the picture. The picture is for
illustrative purposes only.