Setup and Operation
14 Installation and User’s Manual for Wi-Fi Module
Continue Connection Process
1. See
Figure 3-21
. The controller display will
change to
SETUP WIFI NOW!
along with a
timer. You have 30 minutes to connect the
Wi-Fi.
Figure 3-21. Wi-Fi Setup Screen
NOTE: After 30 minutes, the controller will
time out. SETUP WIFI? will reappear on
the controller display. If YES is selected,
the 30 minute countdown timer will restart.
If NO is selected, Wi-Fi setup will be
bypassed.
2. Connect to the generator Wi-Fi network
(MLGXXXX) using a Wi-Fi enabled mobile
device.
3. After the connection is established, open a
web browser and type 192.168.51.1 in the
address bar.
NOTE: The setup page can also be launched
by scanning the Quick Response (QR) Code
on the Wi-Fi data label with your mobile
device if so equipped.
4. See Figure 3-22. Select your country and
time zone.
Figure 3-22. Select Country and Time Zone
5. See
Figure 3-23
. Select the homeowner’s
network name from the drop-down list.
NOTE: If the homeowner’s network is
invisible, select “Manual Configuration” from
the drop-down list and enter the network
credentials.
Figure 3-23. Select Homeowner’s Network
6. See Figure 3-24. Enter the homeowner’s
network password and click CONNECT.
Figure 3-24. Enter Password
To Next Page
Loading...
Need help?
General
