Generac Power Systems NP-30G Series User Manual

ISOLATING DIFFERENT
POWER SOURCES
Conductors from the junction box must terminate in a
double pole, double throw transfer switch (Figure 28}.
An alternate method for isolating different power
sources
is by using an isolating receptacle (Figure 29
on Page 25}. Whichever method you use, you must
be certain that both power sources are NOT connect-
ed at the same time.
POWER SUPPLY CORD
The power supply cord must comply with all applica-
ble
codes, standards and regulations. It must be large
enough to handle the full amperage to which it will be
subjected.
FLEXIBLE
COI\IDIIIT
POWER
SUPPLY
GROUND FAULT CIRCUIT
INTERRUPTERS
The National Electric Code (NFPA 70, 551-7} requires
that you install ground fault circuit interrupters
(GFCis) on all external and some internal electrical
receptacles. Contact your manufacturer or dealer for
recommendations.
DOUBLE POLE/
DOUBLE THROW
SWITCHING.
DEVICE .
VEHICLE WIRING
JOAMP
CORD~
MAII\1 BREAKER
HACR BREAKERS
'==::r:J-----t--=-_rOR AIR
-24-
VEHICLE A-C
DISTRIBUTION
PANEL
CONDITIONERS
~ff::=t=::=::::~FCI
BREAKERS

Generac Power Systems NP-30G Series Specifications

General

Brand	Generac Power Systems
Model	NP-30G Series
Category	Portable Generator
Language	English