Generac Power Systems Protector Series Installation Guidelines

Control Panel Startup / Testing
Installation Guidelines For Spark-Ignited Stationary Generators 37
Figure 6-2. Install Wizard Menu Map
UP ARROW =
+
DOWN ARROW = -
SYSTEM
BAT-
DATE/TIME
SUB MENUS
Language
+ English -
+ Espanol -
+ Francais -
+ Portuguese -
Install Wizard
Set Exercise
Install Wizard
Power Up Unit
Select Hour (0-23)
- 14 +
Select Min (0-59)
- 0 +
ENTERENTER
ENTER
ENTER
ENTER
Select Hour (0-23)
- 14 +
Select Min (0-59)
- 0 +
ENTER
ENTER
Select Month (1-12)
- 2 +
ENTER
Select Date (1-31)
- 13 +
ENTER
Select Year (0-99)
- 13 +
ENTER
FIRMWARE V 1.01
HARDWARE V 1.05
* Holding the Up or Down arrow button for 2 seconds will speed dial through the selections
Defaults to English if not selected. Note: If language was previously programmed this goes directly to “Select Hour”
Use UP and DOWN arrows to select fuel type then press “ENTER”
** ***
*
*
Switched to “OFF”
Hours of Protection
0 (H)
Select Day
- Wednesday +
Select Frequency
- WEEKLY +
- BIWEEKLY + - MONTHLY +
010124
Product Registration
(if not already registered)
Quiet Test Mode + yes - + no -
ENTER
GUI FW V XXX
SEEPROM V XXX
ENTER
Fuel Selection
- LP +
- NG +
ENTER

Generac Power Systems Protector Series Specifications

General

Brand	Generac Power Systems
Model	Protector Series
Category	Portable Generator
Language	English