Control Panel Startup / Testing
38 Installation Guidelines For Spark-Ignited Stationary Generators
Activate Unit
Display Reads:
Generator Active is displayed on
the LCD screen when the unit is first
powered up. After displaying
firmware and hardware version
codes, as well as other system
information, the Install Wizard is
launched, and the Language screen
is displayed.
Use UP ARROW or DOWN ARROW
to scroll to desired language.
Press ENTER.
If the wrong language is selected, it may be
changed later using the Edit menu.
Display Reads:
Press ENTER. Press ESCAPE to abort the activation sequence.
NOT ACTIVATED is displayed and the generator
will run in manual mode only. Disconnect and
reconnect the negative battery cable to restart the
activation routine. If power is removed after a
successful activation, no data is lost, but the time
and date must be updated.
Display Reads:
Go to www.activategen.com or call 1-
888-9ACTIVATE (922-8482, US &
Canada only) if activation passcode
is not available.
If activation passcode is available,
wait a few seconds for the next
display.
Display Reads:
Use UP ARROW or DOWN ARROW
to increment or decrement the digit to
correspond to the first number of the
passcode.
Press ENTER.
Repeat step to enter remaining
digits.
Press ESCAPE to return to preceding digits if a
correction becomes necessary.
If attempts to enter the activation code are
unsuccessful, check the number against the
passcode given on activategen.com. If it is
correct, contact 1-888-9ACTIVATE (922-8482,
US & Canada only).
Language
- English +
Up Arrow = (+)
Down Arrow = (-)
Activate me (ENT) or
ESC to run in manual
To Activate go to
www.activategen.com
SN 1234567890
PASS CODE XXXXX
To Next Page
Loading...
Need help?
General
