To Next PageTo Next Page
Need help?Do you have a question about the Generac Power Systems TAS-200 and is the answer not in the manual?
General| Brand | Generac Power Systems |
|---|---|
| Model | TAS-200 |
| Category | Switch |
| Language | English |
Discusses general hazards associated with the transfer switch operation and installation.
Explains the automatic transfer of electrical loads between normal and standby power sources.
Emphasizes safety rules and compliance with codes for using the transfer switch.
Instructions for safely connecting power source and load lines to the transfer switch.
Outlines how to inspect and perform functional tests on the installed transfer switch system.
Provides step-by-step instructions for manually operating the ATS contactor.
Guides on performing voltage checks to ensure compatibility with the transfer switch.
Describes how to test the electrical operation of the transfer system via the HMI.
Explains the automatic sequences of operation for power source transfers.
Lists and explains the configurable parameters and default values for operation sequences.
Introduces the HMI, its accessibility, and its use for viewing status and changing settings.
Explains how to navigate the HMI to select different configuration screens.
Details settings for Inphase, Transfer Delay, and System Voltage/Phase selection.
Covers settings for Utility Fail and Pickup voltage thresholds.
Details settings for Engine Warm Up, Cool Down, and Minimum Run Timers.
Describes how to configure exercise day, time, duration, and transfer settings.
Accesses test functions for normal and fast test sequences of the transfer switch.
Guides on calibrating utility and generator voltage inputs using the HMI.
Details annual cleaning and inspection procedures for the transfer switch.
