4. Press the ↵ (Edit) key to access the State
sub menu. Using the ▼ (down) key, set
the state to On (indicated by the filled
radio button). Press the ↵ (Edit) key and
verify that the status line confirms the
State is set to On.
5. Press the ▼ (down) key to highlight Start
Time and press the ↵ (Edit) key. Using the
drink selection keypad, set the time at
which the the Backup event will start. If
necessary use the ▲ (up) or ▼ (down) key
until AM appears in the dotted box.
6. Press the ↵ (Edit) key and verify that the correct start time is displayed in
the status line at the bottom of the screen.
7. Press the ▼ (down) key to highlight Days
Of Week and press the ↵ (Edit) key. From
this menu the operator can set the days
on which the Backup event will take place.
To select everyday (Monday - Sunday),
press the START/? key on the drink
selection keypad. The program automatically places an X in every box
indicating that each day is selected.
N.B. To select individual days, scroll through the menu using the ▲ (up)
or
▼ (down) keys until the required day is highlighted. Press the ↵ (Edit)
key to select the day, indicated by an X appearing in its adjacent box.
to select the day, indicated by an X appearing in its adjacent box.
7.8.4 Energy Saving Events Menu
This sub menu enables the Operator to program in periods when the machine
can be in an energy saving mode. In this mode the water in the boiler is not
maintained at the normal vend temperature, but at a lower temperature of
68°C.
During the Energy Saving periods programmed into the machine, vends can still
be dispensed, although none of the drink section buttons are illuminated and
the message ‘Power Saving Mode’ is displayed on the LCD. By pressing any one
of the buttons on the keypad the LCD message changes to ‘Water Tank
Heating’. The machine reverts back to ‘Power Saving Mode’ ten minutes after
the last vend, if still within the Energy Saving Events period. The default setting
for these Events is Off.
58
Operators Manual
To Next Page
Loading...
Need help?
General