• Do not use the system with water that is microbiologically unsafe or of unknown quality without
adequate disinfection before or after the system.
• Do not use the brine tube, injector body, or other connectors on the Genesis Upflow valve as a
handle to carry the system.
• Ensure there is salt in the brine tank at all times when this valve is used for softening. The brine tank
should contain clean water softening salt only, at least 99.5% pure. Only use clean water softener
salt in pellet granular or block form.
• When there is moderate to high turbidity, a filter should be installed before the water softening system
on the inlet side.
• If the water pressure exceeds 120psi, a pressure reducing valve must be installed before the water inlet. If
the water pressure exceeds 80 psi, installing a pressure reducing valve before the water inlet is highly
recommended. If the water pressure is under 20 psi, a booster pump must be installed before the
water inlet.
• Replacement parts for the Genesis Upflow valve should only be purchased through Discount Water
Softeners Genesis resellers. Electrical components, such as transformers, are specific to the Genesis
Upflow valve from Discount Water Softener.
• Regular interval monitoring of the water quality and work environment is recommended to ensure
proper operation of the valve and system.
• Any modification to Genesis equipment, which is outside the standard scope of supply, voids the
product warranty.
• Genesis equipment, like all modern electronic devices, can be damaged by electrical surges or brown
outs. Every effort has been taken to harden the circuits, by design, to protect against such events.
These precautions, or even additional surge protection, are not 100% effective. Therefore, equipment
damage caused by abnormal electrical events is not covered by warranty.
Genesis Upflow V
alves & Systems Service Manual
To Next Page
Loading...
Need help?
General
