Genie TriloG 1500 User Manual

INTELLICODE 1 REMOTES

Remotes provided with this unit can operate other (Intellicode® 1)
models of Genie® garage door openers . The default Intellicode ® 2 setting
must be changed to Intellicode® 1. (Follow these same steps to change
Intellicode® 1 back to Intellicode® 2.)
NOTE: Thebuttondirectlyabovethelogoonthetransmitterispreset
toIntellicode ® 1.
The LED color displayed on the Remote indicates the Intellicode® mode:
Red = Intellicode ® 1 Green = Intellicode ® 2
***Repeat Step 2 to turn the RED LED on the Remote back to GREEN
for operation with Intellicode ® 2 openers.
Once the LED on the Remote turns RED when the button is pressed,
that button is programmed to the Intellicode ® 1.
If your door opener has a black antenna wire and the serial number
does not start with 10 or higher, the Learn Code Button and
Indicator LED are located near the antenna. The light lens may need to
be opened. If you use an external receiver, it may need to be opened
to access the Learn Code Button and Indicator LED.
If you have questions, see your Genie® instructions for this Intellicode® 1
model of opener.
NOTE: ChoosetheGenie ® RemoteusingIntellicode ® 1buttonforthis
activity.AllnewRemoteshavethebuttondirectlyabovethelogo
presettoIntellicode ® 1.
This button is set to Intellicode® 1.
OptionalProgramming
4
1
Select a Remote button NOT already programmed to
the Powerhead. Press and hold the button for 10 seconds
(both the RED and GREEN LEDs on the Remote turn ON).
2
Press and release the Remote button 3 times.
3
Find the Learn Code Button and Learn Code Indicator LED
on your older Genie® door opener.
4
Press the Learn Code Button (the LED on the Opener
5
Press the Remote button 2 times (the LED on the Opener
turns OFF).
6
Press the Remote button again. If the door moves, the
Remote button is programmed to your opener.
14
®

Genie TriloG 1500 Specifications

General

Brand	Genie
Model	TriloG 1500
Category	Garage Door Opener
Language	English