English
-12-
Inserting an SD memory card (optional accessory)
The camera comes with 16MB of internal memory, allowing you to store images and video clips
in the camera. However, you can expand the memory capacity by using the SD (Secure Digital)
memory card so that you can store additional images and
video clips.
1. Make sure the camera is turned off.
2. Slide the battery/SD card cover in the direction of the
[OPEN] arrow.
3. Insert the SD memory card.
The front side of the memory card (printed arrow)
should face towards the front side of the camera.
If the card cannot be inserted, check the
orientation.
This camera is also compatible with the MultiMediaCard
TM
.
4. Close the battery/SD card cover.
To remove a memory card:
Make sure the camera is turned off. Open the battery/memory card cover. Press lightly on the
edge of the memory card and it will eject.
NOTE
y To prevent valuable data from being accidentally
erased from an SD memory card you can slide the
write-protected tab (on the side of the SD memory
card) to “LOCK”.
y To save, edit, or erase data on an SD memory card,
you must unlock the card.
Attaching the Hand Strap
To prevent accidental slippage during use, always use the
strap.
Attach the camera strap as follows:
1. Thread the small loop of the hand strap through the
hand strap eyelet on the camera.
To Next Page
Loading...
