The speedometer displays the current speed of the GenZe 2.0 in MPH. The center of the meter displays the digital
value, while a needle will point to the speed indicated on the touch screen.
Gear:
The gear indicator will display the current gear position as selected by the forward/reverse switch. There are 3
indicated positions “F” forward, “N” neutral, and “R” reverse.
Menu:
Touching this button on the touch screen will take you to the Menu Screen. See
“Menu Screen”.
Back to Top
State of Charge (SOC):
This bar graph will display the amount of energy remaining in the battery pack, similar to the fuel gauge on a
gasoline powered vehicle.
Fault Indicator:
If a fault has been detected, this indicator will illuminate yellow or red indicating the severity of the fault. Yellow is
a caution, which doesn’t require immediate attention, but could limit functionality depending on the fault. Red is a
warning, which requires immediate attention. This will put the GenZe 2.0 into a limited or non-functional state,
depending on the fault.
Turn Signal Indicators:
An arrow on the lower dash flashes green in the same direction as selected by the turn signal switch. This arrow
remains flashing until the turn signal switch has been canceled by pressing in on the turn signal switch.
Back to Top
Drive Mode Selection:
Touching this button on the touch screen will allow you to toggle between Economy Mode (Econ), Sport
Mode (Sport), and Easy/Safe Mode (Safe).
Economy Mode reduces maximum power and torque so greater energy efficiency may be achieved. This mode is
optimized for greater range, while maintaining performance.
Sport Mode Allows you to increase the maximum power and torque to performance limits of the GenZe 2.0. This
will give the best speed performance.
Easy/Safe Mode is designed for new riders. It sets torque and power to a low level.
To Next Page
Loading...