Back to Top
Battery Pack Charging
Your charger will reach temperatures of up to 130° F (55° C) while charging. Be mindful where you leave your battery
while charging and when handling after your charge is complete.
Actual charging times will vary depending on different factors including temperature and current state-of-charge
(SOC). Charging a depleted battery pack to 100% will take about 4-5 hours.
Your charger is designed and tested to standards which allow for safe indoor charging of the GenZe 2.0 battery
pack. During charging, the case temperature of the charger may get warm, and you should exhibit caution when
handling. When charging, the battery pack should be kept off of surfaces which can melt and out of the hands of
children. If the charger is to be used outdoors or in a wet or location, a GFCI outlet or cord should be used. You can
purchase a GenZe 2.0 GFCI protected cord at your authorized dealer.
A green LED is located on the side of the charger and indicates the condition of the charger and where it is at in its
charging process.
Charger error. Unplug the charger for 30 seconds
then plug the charger back in. If the condition
persists, contact your authorized dealer.
!!!!!!!
!!!!!!Battery Charge Status Indicator Screen
The green indicator bar shows the State of Charge (SOC) of the battery while it is connected to the GenZe 2.0 and
charging. Note: Do not remove the battery from the GenZe 2.0 while it is charging.
Note: After removing the charge cable, wait 30 seconds or until the green light on the battery is no longer blinking
before pressing the start button.
To Next Page
Loading...