• Battery Pack. Make sure the State of Charge (SOC) bar graph on the right side of the Main Screen is
indicating a green charge level. To make sure you have sufficient charge for your intended ride, we suggest you
recharge before use. Always keep the charger cord with your GenZe 2.0. This will allow you to charge via any
electrical outlet.
• Electrical System. Check for correct operation of the headlight, turn signals, brake/tail light, and the horn.
• Cargo. Balance and safely secure all cargo.
Back to Top
Starting
1. Grip the handlebar, and place the kickstand in the up position. NOTE: The GenZe 2.0 will not move if the
kickstand is down.
2. Sit on the GenZe 2.0 with at least one foot firmly on the ground.
3. Adjust both mirrors before starting. NEVER ride with one hand while you try to adjust a mirror. Adjust each
mirror so you can see the lane behind and as much as possible of the lane next to you.
4. The main screen will now power up and prompt you for your PIN. Enter your PIN number by touching the
number on the touch screen, and then touch the Enter button.
a. If you haven’t ridden your GenZe 2.0 in a few days, you may experience an extended power up period.
This is normal when your GenZe 2.0 is waking from a power save mode.
5. The Home Screen will now be displayed, and you are ready to ride.
6. Select your ride direction (Forward or Reverse).
7. To avoid losing control, turn the throttle slowly until the speed increases. DO NOT turn the throttle until
you are ready to ride.
Tips for better range:
• Accelerate slowly and smoothly; avoid hard acceleration.
• Release the throttle, and coast whenever possible.
• Maximize regeneration by lightly touching the brake. This will activate regen braking without applying
the mechanical brakes. This allows the GenZe 2.0 to recover the energy from slowing, rather than
dissipating it through brake discs.
Back to Top
Braking
On the right side of the handlebar is the brake lever for the front brake, and on the left is the brake lever for the
rear brake. To slow down or stop your GenZe 2.0, apply front and rear brakes by squeezing the brake levers.
Slowly increase braking as you feel your speed reduce.
If you apply the front or rear brake hard or quick enough, it is possible to lock the wheels. This could cause you to
lose control of the GenZe 2.0 and could lead to serious injury or death. Progressive use of the brakes should bring
To Next Page
Loading...