Adjusting the Speakers
BAL:
Turn this control behind the
FADE
knob to move
the sound between
the
right and left speakers. The middle
position balances the sound between the speakers.
FADE:
Turn this knob to move the sound between the
front and rear speakers. The middle position balances
the sound between the speakers.
Playing
a
Cassette Tape
Your tape player is built to work best with tapes that are
30
to
45
minutes long on each side. Tapes longer than
that
are
so
thin they may not work well in this player.
The longer side with the tape visible should face to the
right. If you hear nothing or hear just a garbled sound,
it
may not be in squarely. Press EJECT to remove the tape
and start over.
Once the tape is playing, use the
knobs
for VOL, FADE,
TREB, BASS and BAL just as
you
do for the radio. The
lighted arrows show which side of the tape is playing.
REW
(1):
Press this button to reverse the tape rapidly.
Press REW or RCLPROG to return to playing speed. If
you press RCLPROG, the tape will also change sides.
R-M
(2):
Press this button to hear the radio when you
are fast forwarding or reversing a cassette tape.
You
can
use the TUNE, SEEK and PRESET SCAN buttons
while
in
the radio monitor mode. The six preset buttons
cannot be used while
in
this mode.
FF
(3):
Press this button to advance rapidly to another
part of the tape. Press
FF,
RCLPROG or EJECT to
return to playing speed.
PREV
(4):
Press this button to go back
to
the beginning
of the last selection. Press PREV again or press
RCLPROG or EJECT to cancel this function.
01
(5):
Press this button to reduce background noise
from tapes encoded with Dolby NR.
Dolby@ Noise Reduction is manufactured under a
license from Dolby Laboratories Licensing Corporation.
Dolby and the double-D symbol are trademarks of
Dolby Laboratories Licensing Corporation.
NEXT
(6):
Press this button to go forward to the
beginning
of
the next selection. Press the button again
or
press RCL/PROG or EJECT to cancel this function.
For NEXT to work properly, your tape must
have
at
least three or four seconds
of
silence between each
selection. If you press RCLPROG,
the
tape will also
change sides.
3-10
To Next Page
Loading...
Need help?
General
