x
Note for Water Resistant Coating on Camera Cover
The camera cover of GV-SD2301 / GV-SD2411 is treated with a water resistant coating that
prevents droplets from forming on the surface. The water resistant coating will slowly wear off
after approximately one year depending on the operating environment.
Proper care and precautions can prolong the life of the water resistant coating. Store the
camera in a dry area before installation. Once you remove the protective film on the camera
cover, avoid touching the camera cover.
Rinsing the Camera Cover
You can clean the camera cover using one of the methods below:
• Rinse with water
• Use an ultrasonic cleaner
• Rinse with pH-neutral cleaning solution (5% diluted)
If there are grease or fingerprints on the camera cover that cannot be removed by rinsing, you
can gently wipe the cover with clean cotton cloth.
• Only wipe the camera cover after it’s dried.
• Make sure the surface is free of dust or debris before wiping to avoid scratching the cover.
IMPORTANT:
1. Do not wipe the camera cover while it’s wet. Wiping a wet camera cover will damage
the hydrophilic water resistant coating.
2. Do not clean the camera cover with cleaning agent containing organic solvent.
To Next Page
Loading...
Need help?
General
