19
GB
• The blind riveting tool should be used exclusively to set blind rivets!
• Safety glasses must always be worn when working with the blind riveting tool!
• Do not use the tool without material! The blind rivet could be ejected from the tool! Never
turn the tool towards yourself or towards another person!
• Do not overload the tool; work within the prescribed work capacity.
• Never use tor store he blind riveting tool is damp/wet environments or in proximity to
ammable liquids and gases (risk of explosion!) and store protected against frost.
• Ensure that the battery is properly secured in the grip.
• Remove the battery when the blind riveting tool is not in use and for repair/servicing
operations.
• The battery may only be charged in the temperature range between 0°C and +50°C.
• Do not use the blind riveting tool as a hammer.
• Keep device, battery packs and charger away from children.
• Depending on the working arrangements, personal protective equipment (PPE) is recom-
mended (e.g. protective clothing, gloves, safety helmet, non-slip shoes, hearing protec-
tion or fall protection).
• The air inlets for the motor must not be obstructed; do not insert any objects into them.
• When setting the blind riveting tool down, make sure that it cannot fall.
• Use only genuine spare parts for repair.
• Repairs must be carried out only by skilled personnel. In case of doubt, always send the
blind riveting tool back to the manufacturer.
• Container complete (H) must always be screwed on when operating the blind riveting
tool.
BT = BULB-TITE
®
MG = MEGA GRIP
®
* available as special accessories to avoid blockages.
Elongated nosepieces and other special nosepieces are available upon request.
1.5 Safety instructions
Caution:
The following safety rules must be observed for adequate protection against electric
shocks, injuries or re hazards:
To Next Page
Loading...
