40
Using the RFID Reader (Optional)
Select models have an HF RFID reader. The reader can read data from HF
(High Frequency) RFID (Radio Frequency Identification) tags.
The RFID reader is enabled by default. To enable or disable the reader, run
the BIOS Setup program and select Advanced Device Configuration
RFID Card Reader. (See Chapter 5 for information on BIOS Setup.)
For optimal results when reading an RFID tag, have the tag face the antenna
in the same orientation as indicated by the icon on the exterior of the Tablet
PC.
NOTE:
When not using an RFID card, do not leave it within or near the antenna
area.
For enhanced applications and customization of the module, contact your
authorized Getac dealer.
Using MicroSD Cards (Optional)
If your model has the microSD card reader, you can use microSD cards for
removable storage media.
To insert a microSD card:
1. Locate the microSD card reader. Open the cover.
2. Align the card with its connector pointing to the slot and the connector
side facing back. Slide the card into the slot until it reaches the end.
3. Windows will detect the card and assign it a drive name.
4. Close the cover.
To Next Page
Loading...
