64
Check the cables or power cords for correct connections.
For an external device that has its own power switch, make sure that the
power is turned on.
Power Management Problems
The Tablet PC does not enter Sleep or Hibernation mode
automatically.
If you have a connection to another computer, the Tablet PC does not
enter Sleep or Hibernation mode if the connection is actively in use.
Make sure that the Sleep or Hibernation time-out is enabled.
The Tablet PC does not enter Sleep or Hibernation mode
immediately.
If the Tablet PC is performing an operation, it normally waits for the
operation to finish.
The Tablet PC does not resume from Sleep or Hibernation mode.
The Tablet PC automatically enters Sleep or Hibernation mode when the
battery pack is empty. Do any one of the following:
− Connect the AC adapter to the Tablet PC.
− Replace the empty battery pack with a fully charged one.
Wake-on-LAN (WoL) doesn’t seem to work.
If your Tablet PC is connected to an older generation of office or vehicle
dock, waking up from Microsoft Modern Standby mode is not supported.
Software Problems
An application program does not work correctly.
Make sure that the software is correctly installed.
If an error message appears on the screen, consult the software program’s
documentation for further information.
If you are sure the operation has stopped, reset the Tablet PC.