<Doc_USR><Doc_502404300><Rel_A><Lang_GB>
Page 10 of 24
Machine with barcode scanner
Every wash trolley has its own unique ve-digit number. The rst two digits indicate
which wash program is to be used; the third digit is for extra equipment and the last two
are the trolley’s ID.
Loading goods to be washed into the machine
Load the items to be washed on to the trolley and run the trolley halfway into the
machine. Examples showing how to load the trolley are shown on the goods posi-
tioning sign.
A fine filter must be used when cleaning and disinfecting tubular instru-
ments with a passage smaller than 2 mm, to prevent particles getting stuck
in the instruments. Blocked or reduced water flow may result in cleaning
and disinfection failing to take place.
•
Fixed scanner
Choosing a program
Scan the barcode of the trolley with the barcode scanner. For a machine with a xed
scanner, the trolley must be moved so that the barcode gets scanned. On the basis of
the barcode, the machine automatically chooses the correct wash program.This is
what to do if you want to use a different washing program from the scanned one:
- Press one of the program selection buttons 1 -6
- Press S. The display now shows “CHOOSE PROGRAM”.
Press S again.
Choose a program from the list with H and J.
Press S to conrm your choice.
Run the trolley into the machine.
Close and lock the door. The program then starts automatically.
If the program is cancelled after start, the cleaning result and disinfection will
fail to take place.
•
•
•
V1589
To Next Page
Loading...
Need help?
General
