Getinge 88-SERIES - Page 20

<Doc_USR><Doc_502404300><Rel_A><Lang_GB>
Page 20 of 24
A15 Not enough detergent 2 dosed
A16 Not enough detergent 3 dosed
A17 Not enough detergent 4 dosed
A18 High conductivity.
A19 Low pressure in drying unit.
A20 High pressure in drying unit.
A21 Low pressure from circulation pump.
A22 High pressure from circulation pump.
A23 Low temperature in drying unit.
A24 Faulty temp sensor in booster tank.
A25 Faulty temp sensor (controlling) in wash chamber.
A26 Faulty temp sensor (independent) in wash chamber.
A27 Faulty temp sensor in dryer unit.
A28 Faulty temp sensor in wash chamber. (Temperature too low because of a
heating fault).
A29 Faulty temp sensor in wash chamber. (Sensor fault)
A30 Faulty temp sensor in wash chamber. (Temperature too high because of a
heating fault).
A31 High temperature in drying unit.
A32 High temperature in booster tank.
A33 Low disinfection temperature.
A34 The drain tank takes more than 3 minutes to empty.
A35 The waste outlet valve of the process tank does not reach the open or closed
position.
A36 The waste outlet valve of the wash chamber does not reach the open or
closed position.
A37 The wash chamber tank takes more than 25 seconds to ll with water.
A38 Faulty temp sensor in booster tank. (Temperature too low because of a
heating fault.)
A39 External stop signal.
A41 Faulty circulation pressure sensor.
A42 Faulty pressure differential sensor in drying unit.
A45 Monitoring system: Disinfection time + 60 sec. See under “Fault codes in
independent monitoring system.”
A46 Monitoring system: Discrepancy between temperature sensors in the cham-
ber; see under Fault codes in independent monitoring system.”
A47 Monitoring system: High conductivity; see under “Fault codes in
independent monitoring system.”
A48 Monitoring system: Disinfection time + 60 sec. See under “Fault codes in
independent monitoring system.”
A49 Monitoring system: Too little detergent dosing (it takes more than 5 minu-
tes to reach sufcient volume), see under “Fault codes in independent
monitoring system.”
Fault code Description