Maintenance and inspection procedures
Mechanical inspections
4
Lucea 50_100
01740 EN 01
21 / 44
Fig.18: Fitting of cover
• Check that the cover is firmly in place.
Fig.19: Replacing the screws
• As a preventive measure, every six years,
replace the screws securing the suspen-
sion tube to the anchor plate, as well as
the screws for the suspension end caps.
• Tighten to specified torque; use pre-glued
screws.
Fig.20: Checking the rigidity
• Check the rigidity of the configuration by
shaking the assembly.
To Next Page
Loading...
