SV200 R200
4/2007© by GLOBAL GARDEN PRODUCTS
Carburation problems
Governor blocked
Lawnmower problems
The engine brake cable is bent
or jammed
Electrical problems
The earth cable is disconnect-
ed or broken
Lawnmower problems
Blade not balanced
Engine screws loose
Engine shaft bent
The breakage of the internal device counter-
weights does not allow opening of the butterfly
to be opposed.
Excess dirt or a broken spring can impede the
movements of the governor or impede return.
When the lever is released, the earth micro-
switch is not pressed.
The broken or disconnected cable prevents the
microswitch from closing the electric circuit to
earth
The imbalanced or loose blade causes judders
and the premature wear of all the parts inside the
engine.
An engine with loose screws can be hazardous
for the user and can break internal parts.
An impact of the blade against an obstacle could
lead to deformation of the engine shaft.
Check the entire
governor system
[
6.5]
Check and/or adjust
the cable [
6.7.A
]
Check the earth con-
nection [
6.7.B]
Dismount and balance
the blade and tighten
the screws to the
specified levels
Tighten the screws to
the specified levels
[
6.10.A
]
Replace the engine
shaft [
6.10.C]
5.1.1
TROUBLESHOOTING
6 / 7
SERVICE MANUAL
page
from
2007 to ••••
J) The engine judders
Probable cause Comment Solution
G) The engine overreved
Probable cause Comment Solution
H) The engine does not turn off
Probable cause Comment Solution
To Next Page
Loading...
Need help?
General
