Ghost Controls Ghost Pro Series - Installing Control Box and Battery Box; Step 7: Determine Mounting Location; Mounting Control and Battery Boxes; Control Box Power Switch

45
PUSHTOOPEN
©Ghost Controls
®
2020
INSTALLING THE CONTROL BOX AND *BATTERY BOX KIT
(*BATTERY BOX KIT (ABBT2), NOT INCLUDED.)
STEP 7. Determine the mounting location for the control box and *optional battery box. The battery
and control box must be located within 4 feet of each other. Then install.
NOTE
Mount the control box a minimum of 3 feet above the ground to keep dirt and water from damaging the control board
and within 4 feet of the operator arm in order for the operator cable to reach the control box.
A. Pre-drill (4) holes (7/32˝ drill bit) in backside of control and optional battery box, and through the fencing
where you will be securing the control box and battery box.
B. Now use the (4) supplied phillips screws for each box to mount the control box and optional battery box to
the fence.
C. Make sure the on/off switch on the bottom of control box is in the off position.