Ghost Controls Ghost Pro Series - Monitored Safety Devices - Photo Eyes (AXPE); Accessory Signal Input Logic; Open Input Terminal (OPEN); Closing-Reverse Input (CLS-RVRS)

63
HARDWIRED ACC.
©Ghost Controls
®
2020
■ Active — Signal must go from INACTIVE then ACTIVE for the system to recog-
nize the input and respond accordingly.EX: OPEN > STOP > CLOSE > STOP >
OPEN >...
OPEN INPUT OPEN: Use this terminal for Ghost Controls Vehicle Detector
(AXXV).
Active — OPENS gate to full open limit and prevents it from closing,
if it remains active.
CLOSINGREVERSE INPUT CLSRVRS: Use this terminal with photo eye
beams or safety edge.
■ Active — Prevents gate from CLOSING or reversing to open limit if it was
CLOSING.
OPENINGREVERSE INPUT OPNRVRS: Use this terminal with photo eye beams or safety edge.
■ Active — Prevents gate from OPENING or reversing to close limit if it was OPENING.
MONITORED SAFETY DEVICES  PHOTO EYES AXPE
NOTE
Please refer to manufacturers manual or website for more detailed instructions on how to connect and use accessories with
your gate opener.
TERMINALS TO USE FOR REVERSE OPENING:
■ PWR = Switched 12 Volts (+)
■ MS–OP1 = Photos beam’s output for 1st arm open-direction protection
■ MS-OP2 = Photos beam’s output for 2nd arm open-direction protection
■ COM = Battery
IF THE BEAM IS BLOCKED OR DEVICE IS DISCONNECTED
■ Gate can not be open if idle
■ Gate will reverse direction and run to the closed position if it was opening
TERMINALS TO USE FOR REVERSE CLOSING:
■ PWR = Switched 12 Volts (+)
■ MS-CL1 = Photos beam’s output for close-direction protection
■ COM = BATTERY NEGATIVE
IF THE BEAM IS BLOCKED OR DEVICE IS DISCONNECTED
■ Gate can not be closed if idle
■ Gate will reverse direction and run to the open position if it was closing