22K
You can use [Volume Up/ Volume Down] key to
switch “ON / OFF”. When this item is switched to
“ON”, receiver will receive TV and radio input
signal from 22K port. If the item is switched to
“Off”, the receiver will receive all signals from 0K
port.
! Notice
When you choose LNB type “Universal”,
you cannot modify 22K.
0/12V
You can use [Left/ Right]key to switch “on /off”.
Polarity
In “Polarity” item, [Volume Up/ Volume Down]
key to switch “Auto / H / V” functions.
Tonebusrt
In “Toneburst” item, you can press [Volume Up/
Volume Down]key to switch “Off/On” functions.
LNB Power
In “LNB POWER” item, you can press [Volume Up/
Volume Down] key to switch: ” Off、13v/18v、
13.5V/18.5V ” functions.
TP Edit
When you enter to “TP Edit” menu, there will
display the screen like below:
1 In “Satellite” item, press[Volume Up/ Volume
Down]key to switch satellite that you want to
scan or press[OK]key to enter satellite list for
selection.
2 In “TP Index” item, you not only can use
[Volume Up/ Volume Down]key to select
transponder but also can use[Add] and
[Delete]functions.
When you press [Green] key, it will display
“New TP” in “TP Index” item; You should
set the parameters of “TP Frequency” and
“Symbol Rate” for this new transponder.
The parameters of “TP Frequency” and
“Symbol Rate” can set by number keys.
The available range are “3000~13450
MHz” and “1000~45000Ks/s”.
When you press[Yellow] key, there will
show up a warning message for reminding
whether you will delete the current
transponder or not. If you select “Yes”, the
current transponder will be deleted, and the
total account of transponder will reduce 1
correspondingly.
When you press [Blue] key, there will show
up a warning message for reminding
whether you will delete all transponders or
not. If you select “OK”, all transponders will
be deleted.
3 For the existed transponder, you also can
use number keys to modify the parameters
of “TP Frequency” and “Symbol Rate”.
4 When you complete your modification,
Press [Red] key, it will show up a dialog to
ask you scan mode, program type, scan
type and NIT Search on/off. After you set
up, press [OK] key to start scanning.
5 In the “TP Scan” item, press [Exit] key to
exit the scanning and save the current
parameters.
To Next Page
Loading...
