This function can upgrade the software through
signal lines from the satellite
1 Select the satellite and TP or input the TP
value and download PID, these parameters you
can get from your provider.
2 Then move the highlight to the start button
and press [OK] button to start upgrade.
12.4 Upgrade By USB
In this menu you can upgrade the software from
USB conveniently, Press “Left/Right” button
select USB A or USB B; press ' OK ' button to
enter.
In this menu you can select the Upgrade Mode
among Software(No channel list), Channel list,
All SW+bootloader and All SW+Channel list,
and you can select the appropriate upgrade file
on "Upgrade File" item. After you select the
"Upgrade Mode" and "Upgrade File", press ' OK
' button on "Start" item, the receiver can upgrade
automaticlly.
NOTE:
You must put the upgrade file on the /ROOT
DIRECTORY of the USB storage.
12.5 Backup to USB
In this menu ,you can dump the software to the
USB equipment
1.In "Backup file",you can press [OK] key to
edit the file name.; Press “Left/Right” button
select USB A or USB B;
2.In "Backup to USB", you can press [OK] to
start backup software .
To Next Page
Loading...
