12. System
When you enter to “System” menu, you will see
a screen like below:
In “System” menu:
1 Press [Up/Down] key to select menu pages
among Information, Default Setting, Software
Upgrade, Upgrade By USB, Backup to USB
2 Press [OK] key to enter the selected item.
12.1 Information
1 When you enter to “Information” menu, you
will see a screen like above. The screen
displays :MODEL ID,S/W VERSION,H/W
VERSION,LOADER VERSION,LATEST
UPDATE,STB SN,STB ID,CHIP ID.
2 Press [MENU] key to draw back to ““Information””
menu.
12.2 Default Setting
12.2.1 Default Value:
When you press [OK] key In the “Default
Setting” item:
1 There will pop a dialogue for you to enter
the password, and the default password is
“0000”.
2 After you input the correct password,
there will show a warning message to
inquiry you “The operation will load default
and erase all the channels that user
added, continue?”.
3 If you select “OK” option, the all revised
parameters of the receiver will reset to
default value. Please carefully to using
this function.
4 In step 1 and step 2, press[Exit]key can
draw back from this item and without
saving.
To Next Page
Loading...