FT-M1211A 20
2 HANDLING AND INSTALLATION
2.1 HANDLING
The handling of the machine must be done by qualified personnel.
During handing, nobody should be under the load.
The machine must be handled using the hoist rings otherwise you risk in
twisting the machine.
Use the hoist rings intended for this procedure.
Make sure that the machine is properly balanced.
An elevator carriage should only be used if the following conditions are
met: the elevator carriage«forks» must span the entire width of the FT-SMART.
Verify that the forks do not touch the stacker flaps.
To Next Page
Loading...