GIGA-BYTE TECHNOLOGY GA-X99-Phoenix SLI User Manual

- 28 -
Hardware Installation
To enable hot-plugging for the SATA ports, refer to Chapter 2, "BIOS Setup," "Chipset\PCH sSATA
Conguration,"formoreinformation.
10) sSATA3 0/1/2/3 (SATA 6Gb/s Connectors)
The SATA connectors conform to SATA 6Gb/s standard and are compatible with SATA 3Gb/s and SATA
1.5Gb/s standards. Only AHCI and IDE modes are supported. Each SATA connector supports a single
SATA device.
1
1
Pin No. Denition
1 GND
2 TXP
3 TXN
4 GND
5 RXN
6 RXP
7 GND
sSATA3
3 1
2 0
DEBUG
PORT
G.QBOFM
7
7
DEBUG
PORT
G.QBOFM
11) U2_32G (U.2 Connector)
The U.2 connector supports a single U.2 device. Note: When an i7-5820K or i7-6800K CPU is installed,
the U.2 connector becomes unavailable.
F_USB30
F_U
B_ 
F_  F_ 

_
B
BS_
B
SB_
B
_S

S_
_
B
_U
_
B


 
S  
 
123
 
123
 
123
 
123
1
1
1
1
BSS
S
_S 
SSU
 
1 2 3 4 5
 S3
BSSS
U
 __ 3
F_USB3F
S  _
S  _
S  _
SF


B_
B_
F
_0
S
S
_0F
_F
_
_
__B


U
S  _S

GIGA-BYTE TECHNOLOGY GA-X99-Phoenix SLI Specifications

General

Brand	GIGA-BYTE TECHNOLOGY
Model	GA-X99-Phoenix SLI
Category	Motherboard
Language	English